Clean the machine: Open the inspection hole cover on all parts of the machine, remove all protective covers, remove the remaining debris in the drum room, the bridge conveying room, clean the small jitter board, the cleaning chamber bottom case, the gearbox outside, the header, Residues of straw, soil, etc., remaining on the bridge, engine exterior, etc. After the cleaning is completed, start the machine and allow each part to run at high speed for 3-5 minutes. Drain all remaining materials, rinse the outside of the machine with water, and then start the machine at high speed for 3-5 minutes to remove the remaining water.
Lubrication: Lubricate according to the lubricating chart of the combine harvester, the lubrication table and the diesel engine manual, then use the small and medium throttle to idle the diesel engine for 5 to 10 minutes.
Maintenance knife: first move, set the knife apart, remove the soil attached to the knife and other residues, and then check whether the blade riveting loose, whether the excessive wear and tear, with or without deformation of the knife. If the loosening should be promptly riveted, if the wear exceeds the standard, replace it, if the cutter bar is deformed, correct it. Then it is reinstalled as required, and the gap between the fixed blade and the movable blade after loading is within 0.2 mm. The power rod should be smooth and smooth without any stagnation, and then it should be oiled and rustproof.
Overhaul of the threshing drum: Replace the threshing arches with excessive wear, and correct the side of the bow.
Check the fasteners: If the fasteners are loose or loose, they should be repaired or fastened in time.
Check the drive chain: Remove the drive chains and clean them. Check if there are cracks or other qualitative changes in the chain sets. If so, replace them in time.
Servicing the drive belt: Remove all the drive belts to see if there is any slipping, burn, or aging, damage, etc. due to long use time, if any, replace them. The belts that can be used continuously should be cleaned, dusted with talcum powder, installed in place, and adjusted as required before harvesting in the next season.
Brushing paint: Clean the surface of the metal paint stripping machine, and make up the paint.
Amy Hookah,Zinc Hookah ,Zinc Alloy Hookah
Fenghua Jade Motor Co., Ltd. , http://www.qiuzanhookah.com