Electromagnetic drum wok precautions

To avoid possible danger or electric shock, please pay attention to the following before use:

1. The equipment must be connected to the ground wire before use. Check the hydraulic motor clockwise before starting the machine. Turn on the heating system after the cylinder is rotated. After the heating stops, the main unit cooling fan can be turned off.

2. Do not touch the electromagnetic roller and its power cord when the hand is wet. Do not pull the power cord to move the electromagnetic roller or move the electromagnetic roller while the electromagnetic roller is loaded with the pot or working.

3. Do not use the electromagnetic roller and other electrical appliances on the same control box. Connect it to the appropriate control box with leakage protection. Always check the power cord connection device. If the cord is damaged, do not use the electromagnetic roller and replace it with a full-time staff.

4. Do not place metal cans or metal bodies on the surface of the electromagnetic roller or under the furnace. Do not use the electromagnetic roller on a metal plate such as an aluminum composite panel.

5. If the electromagnetic roller is damaged, if it is damaged or the function is malfunctioning, please stop using it and send it to the repair center for maintenance. Only professional personnel are allowed to repair the electromagnetic roller with original accessories. Do not attempt to repair it yourself.

6. Do not be in an unsupervised state when using the electromagnetic roller. Do not place the electromagnetic roller where the child can touch it. Do not wash the electromagnetic roller with water or other liquids directly, or immerse it in water for cleaning.

7. The electromagnetic roller needs to be placed horizontally on the table top. Do not use the electromagnetic roller on the surface of flammable materials (such as tablecloths, carpets, etc.)

8. Do not fill the vents of the electromagnetic drum, which may cause the electromagnetic drum to overheat. The electromagnetic roller should be used at least 8-10 cm above the surrounding wall.

9. Do not place the electromagnetic roller around an open flame, heater or other heat source. Make sure that the power cord unit is free from or pinched by other objects. Do not allow the power cord to enter the electromagnetic body and touch its accessories and the heated roller surface.

10. This equipment must be grounded to the neutral line before use, and it is not allowed to be used without connecting the ground wire.

11. When using the electromagnetic roller, do not place magnetic objects such as magnetic tape on the electromagnetic roller.

12. Do not insert foreign objects such as wires into the vents. This situation can result in electric shock.

13. Do not place the opened cans on the surface of the electromagnetic roller to prevent it from bursting due to heat.

14, the motor should be lubricated to ensure normal use.

15. The pot body should not be dry during use and must be used in the presence of materials.